KOMAS EPOXY NX 2000 & NX 2050
Epoxy resin and cycloaliphatic amines based system, same characteristics as per KOMAS EPOXY NX 2000 & NX 2050 system but with PHR 100: 50 and lower viscosity.
- Before applying the product, clean and slightly rough the surfaces to be glued. Mix thoroughly component A and component B with 100:50 ratio until reaching a homogeneous blend (we suggest to weigh exactly the quantity of part A and part B to use before mixing them).
- The mixture obtained can be processed up to a maximum of 30'. From the application: workable after 24 hours. After 7 days of application, the compound achieves maximum stability. Caution: heat accelerates the hardening of the mixture, while the cold slows it down considerably.
- Do not put the mixed product inside the jars once the application is over. Close the containers well. Test before use. Observe the percentage between the two parts indicated. Cannot be used at temperatures below 10 ° C.
Product Description
| PACKING | ||
|---|---|---|
| 1 KG RESIN + 500 GM HARDNER | 4 KG RESIN + 2 KG HARDNER | 20 KG RESIN + 10 KG HARDNER |
| CHEMICAL AND PHYSICAL PROPERTIES | |
|---|---|
| APPEARANCE | liquid, clear |
| VISCOSITY | 900-1500 mPa.s (25°C) |
| DENSITY | g/cm³ 1.14 |
| FLASH POINT | >150 |
| GEL TIME (150 gr. At 25°C) | 50-60’ |
| PHR | 100:50 |
STORAGE: The product, kept at low temperatures and in perfectly sealed containers, is guaranteed for 12 months. If crystallization occurs, it is sufficient to heat the product to about 60° C to reuse it without any alteration to its physical and chemical characteristics.
| CHEMICAL AND PHYSICAL PROPERTIES | |
|---|---|
| APPEARANCE | liquid, clear |
| ACTIVE CONTENT | 100% |
| VISCOSITY | <200 mPa.s (25°C) |
| AMINE VALUE | 200-400 mg KOH/g |
| GEL TIME (150 gr. At 25°C) | 50-60’ |
| PHR | 100:50 |
STORAGE:The product, stored at temperatures between 5 and 30 ° C, and in perfectly enclosed containers, is guaranteed for 12 months. Lower temperatures may cause an increase in viscosity that may give rise to problems of transfer and manipulation. It is important that the containers are well-closed because: if the product comes into contact with moisture and carbon dioxide, during use, bubbles may develop during the hardening process. Apply and work in an aerated environment.
Explore Other Products: KOMAS EPOXY NX 1000 & NX 1050